Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to Tacoma3G.com, a free resource for 2016-2023 Toyota Tacoma owners!
Tacoma3G is a beginner-friendly 3rd Generation Toyota Tacoma forum (2016-2023 model-year specific). We are a small community of people who are focused on good information and good vibes. More about us....
Softopper 6 months old, but only on my truck for about 3 months. Hate to sell but going a different route. Storage boot included, cost me 850+ asking 700obo. Also have an airbedz inflatable mattress for the long bed taco that I’m asking 100 for, only used twice. Located in Ventura,ca
Thanks fellas! Here’s the light output photos.
First is passenger side, ditch light off. Next is passenger side ditch light ON.
Then only ditch lights on And finally ditch lights, lows and fogs (led) all on. ??
Hey guys, I recently installed ditch lights. I went with RUN-D lights off amazon for around $100. Paired with Rago fab low pro brackets. I did research before purchasing, from the $20 auxbeams to $300 kc’s. Very happy with the light output, each are RATED at 2800 lumens. You’ll notice these have...
Hey guys I’ve been busy with little projects lately and I wanted to share.
Paint matched chrome grill trim. It really bothered me cause there isn’t much other chrome on the truck so it looked out of place. For $19 I got a rattle can of cement (1H5 color code). I removed the grill and the trim...
Here’s my ? with recently installed Softopper And here’s my bone stock ? @ rowher. Driver rear tire is a good 6” off the ground, kinda hard to tell. More impressed with my truck every time I hit the trail.:p
Im a Toyota industrial equipment field service tech, so I know how toyota designs their products. That and the reliability they’re known for was enough for me. Last vehicle I owned was a mazdaspeed3, which I switched to e85 and did just about all mods that could be done. Eventually got tired of...
Made a quick disconnect bracket for my Jerry can mount. Using 12” & 8” zinc plates, 1/4-20 bolts and nylocs. 3/8-16 T-slot nut shimmed with washers is what the mount attaches to. I chose to use a knob which you can find at Lowe’s, it’s a 3/8-16 and 1-1/2” in length. So when I want to use my bed...
Hey guys my names Rob I’m new to the forum. I have a 2019 cement off road long bed. Below are pics of the few little projects I’ve done. Paint matched stock grill trim and interior stereo trim. Cement color code is 1H5 btw. Also added an auxiliary reverse light with some install pics. Tapped...