Recent content by Aven2rus

Anyone experienced selling a truck with money owed to an individual, financed through Toyota? Always used banks in the past and simply went in, so unfamiliar territory here.

$300 for both the Intake and Scoop Toyota Tacoma 16-22 V6-3.5L Part Number: 54-76005 Everything there and remove from Truck, Filter will need to be cleaned. Included is the Dynamic Air Scoop P/N: 54-76005-S (Sold Separately) +17 HP / +19 lbs. x ft. Torque max gains Momentum Intake (New cost...

Going to be on some rocky trails here in the northeast in a couple months for a trail ride and wanted to address the hitch mount hanging up and getting trashed. Nothing I found addressed the forward motion and protected the entire assembly, so fabricated this over the weekend. The 90 degree...

2-1/2" Stainless Steel Cat-Back Exhaust System https://afepower.com/mach-force-xp-2-1-2-cat-back-stainless-steel-cat-back-exhaust-system Was in truck for 1 year. $300, is $648 new. Also have the Stock Exhaust removed at around 1000 miles $100 Lake Ariel, PA

This is starting to read like an advertisement......trolled???

Carfax is helpful but not always enough information to understand the title change. Biggest concern I would have is that flood damage vehicles fall into this area of concern. Flood damaged vehicles are often sold in another part of the country from where the damage occurred, so a buyer is less...

What puller did you purchase? The Puller, Bushing and Seal was only a total of $130 from ECGS, ordered last week.

Completed the switch installation and very please with this, economical priced, function and quality. Used a fuse tap to grab power out of the fuse box, drilling the hole so the wire is forced through to maintain a seal. Always use shrink wrap connectors and a second layer of shrink wrap for a...

OK 4WD

Victory 4x4 Bed Stiffeners installed. Simple task really. Removed Headlight & OE hardware, scribbed the holes, center punched them and used a step drill until the scribe disappeared. De-burred the holes and painted them, installed the new hardware. I also placed the hoops I removed from the...

That Victory 4x4 will best meet you criteria as it protrudes the furthest allowing it to function as a step more so than most. I have thier Blitz and it functions more of a slider/rocker protection, smaller foot hold area like others, but uses same bolt on mounting and was a quality fit and...

So I have not shown much with the wiring in regards to the Bumper Light, Rocker lights and TRD driving lights I installed as I ran to switches installed to the dash and was not happy with the scattered locations as a result of using the Toyota open location. That and wanted a shutoff for the...

Bringing this into my build page from the Armor section. Victory 4x4 Front Skid Plate and Mid Skid Plate installation. Went with aluminum to keep the weight down to a minimum. Fit and finish on these was excellent and working with the reduced weight of the aluminum is a bonus. All access points...

Victory 4x4 Blitz Rockers installed. Love the look, function and fitment was great. t These are aluminum so no worries about rust while keeping the weight down and highlift jack points meets my top concerns and lighting included saves figuring out what you need and spending extra dollars...