Recent content by Asmara

Not really sure. If you don't have heated seats in your O/R, then unless the O/R commonly comes with heated seats, you will likely have to do some wiring. Some of the wiring will be there like in my SR5 which has some partial wiring. Some may not be. If you are pulling from the junk yard, I'd...

The Sky Blue wire at IE2 (if you have it) goes to the driver's side heating element in a factory install. You could technically try to splice into it and use it instead of the wire that comes with your seat heaters, but depending on how the aftermarket ones are set up, it is probably more pain...

I would say unlikely. You'd have to figure out how much current that circuit can support and I doubt it will support seat heaters.

Mine was a generic one with the correct looking switches from Amazon.

There is no difference. For the combined wiring, I was just saying instead of doing what you are talking about I basically just extended the IE2 wire to the area behind the switches and made my connections to both seats there. Either location is fine.

I had similar problems and switched to an AAwireless Android Auto adapter. Until I saw your post, I had forgotten that I had ever had dropouts with AA. Rock solid with wireless.

Somebody needs to post the wiring diagram (or at least the entire instructions) from the Clazzio kit since that seems to be the most common for questions. Let's work backward on your questions. Note that I don't have this kit, but based on previous questions, I will make some educated guesses...

Switch type doesn't matter. Everything is the same as far as the factory connection points.

That is really weird. I double-checked the URL before I posted and it was working. The site is down for me right now too. Maybe try again in a few days. When I was wiring up my seat heaters and needed the diagrams (that site above didn't have my year if I recall correctly), I just subscribed...

This website (in Russian but use your browser to see English) has wiring diagrams. http://zatonevkredit.ru/

Almost. Mine does not have wiring to the center console. Different aftermarket systems work differently but on mine the electrical goes IE2 through the switch to the aftermarket relay to the seat heaters. My relay doesn't work like one would expect (separate a high current drawn from passing...

Sounds like you are overthinking it. If you already have seat heaters installed, just move the power wires from the USB to IE2 and drop in a relay. The IE2 tap just provides power from the factory location. All the different seat heaters have different wiring but basically you follow those...

That is the wire. That connector (with the sky blue wire) plugs into IE2. You would be hard-pressed to even see the back of IE2 although someone with an SR didn't have the wire in the front, it did exist in the back.

A. Double check the wiring. I have a 2021 SR5 double cab. It it possible that the access cab (if that is what you have) is different. I might have that wiring diagram somewhere but I only saved the double cab diagrams when I accessed the TIS. B. Yes, you can draw from the same source without a...